14
Fabric Watch Administrator’s Guide
53-1002752-01
Threshold triggers
2
In-between buffer values
The
below high threshold
is the term used to configure “in between” buffer values, as shown in
Figure 1
. In this example, the high threshold value is 5 and the buffer value is 1. Therefore, the
“in-between” boundary value is 4. Enter the portThConfig command using the following
parameters.
portthconfig
--
set port -area crc -highth -value 5 -trigger below -action raslog
-buffer 1
Above high threshold
Above action = 5
_______________________________________________________________________________
HIGH THRESHOLD, BUFFER = 1
_______________________________________________________________________________
Low action
Below high threshold
In-between
Above low threshold
Above action
______________________________________________________________________________
LOW THRESHOLD, BUFFER=1
______________________________________________________________________________
Low action
Below low threshold
FIGURE 1
In-between buffer values
Threshold triggers
This section describes how Fabric Watch compares a fabric element’s data value against a
threshold value to determine whether or not to trigger an event. It describes how a specified buffer
zone affects event triggering.
For Fabric Watch to monitor data values for one of the following conditions, the alarm setting must
be set to a nonzero value.
Summary of Contents for Fabric Watch
