FIGURE 24
Redistributing OSPF and static routes to RIP routes
You also have the option of specifying import of just RIP, OSPF, BGP4, or static routes, as well as specifying that only routes for a
specific network or with a specific cost (metric) be imported, as shown in the command syntax below.
Syntax:
[no] redistribute
{
bgp
|
connected
|
rip
|
static
[
route-map
map-name
] }
NOTE
Prior to software release 04.1.00, the
redistribution
command is used instead of
redistribute
.
For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following commands.
device(config)# router ospf
device(config-ospf-router)# redistribute rip
device(config-ospf-router)# redistribute static
device(config-ospf-router)# write memory
Configuring OSPF
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
249
Summary of Contents for FastIron SX 1600
