Mounting the access point
2
18
Brocade Mobility 7131 Series Access Point Installation Guide
53-1001935-02
8. Connect the light pipe to the bottom of the access point. Align the tabs and
rotate approximately 90 degrees. Do not over tighten.
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Place the decal on the back of the badge and slide the badge onto the light
pipe from the finished side of the tile.
11. Attach the antennas to their correct connectors.
For information on the antennas available to the access point, see
“Antenna
options”
on page 7.
CAUTION
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the access point.
12. Brocade recommends attaching safety wire to the access point safety wire tie
point or security cable (if used) to the access point’s lock port.
13. Align the ceiling tile into its former ceiling space.
14. Cable the Mobility 7131 Series Access Point using either Power over Ethernet
(PoE) or an approved line cord and power supply.
For POE installations, connect an RJ-45 CAT5e (or CAT6) Ethernet cable
between a PoE switch port and the Brocade Mobility 7131 GE1/POE port.
For standard power adapter and line cord installations:
