Brocade Mobility 7131 Series Access Point Installation Guide
27
53-1001935-02
Chapter
3
Basic Mobility 7131 Series Configuration
For the basic setup described in this guide, the Java-based Web UI will be used to
configure the access point. To access the access point using the GE1/POE port, the
GE1/POE port default setting is DHCP client. For this example, the access point’s
WAN interface will be used to connect to the access point. The default WAN IP
address is 10.1.1.1. For optimal viewing of the Web UI, the screen resolution should
be set to 1024 x 768 pixels or greater.
NOTE
For advanced configuration options beyond the scope of this guide, refer to the
Brocade Mobility 7131 Series Access Point Product Reference Guide.
The guide is
available at
http://www.brocade.com/support/
.
1. Start a browser and enter the following IP address in the address field:
https://10.1.1.1
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available
from Sun’s Website), and be sure to disable Microsoft’s Java Virtual Machine if
installed.
NOTE
The computer being used should be configured to use the same IP address and
subnet mask as the access point.
