Comfort-Tilt
18
All Broda Comfort Tilt
’s are equipped with anti-tippers which are removable and
adjustable. However, they should always remain attached to the chair and pointed
downward and adjusted to the longest possible setting. The anti- tippers can be pointed
upward if necessary for traveling over a curb or such, however they must be returned to
the standard downward position for standard traveling and when the chair is in a
stationary position.
Adjusting the Anti-Tippers
1. Guidance for the anti-tipper height location holes is provided in the Table in Section 4.7.
For making the height adjustments, the detent pin can be depressed, and the anti-tipper
height adjusted.
2. Guidance for the anti-tipper receiver mounting position is provided in the Table in Section
4.7. For making this adjustment, the receiver is removed using
two ½” wrenches and
undoing the bolts identified below (remove the anti-tippers, see item 3 in this section).
Reinstalling the receiver to the alternate position in the table requires the component
being stalled on the opposite side. So, if you are going from the lower position, the
receiver is mounted on the opposite side and in the upper position. Reinstall the bolts.
3. To remove the anti-tippers, the detent pin on the receiver can be disengaged and the
anti-tippers slid out. The detent pin may be on the top or bottom, depending on how the
receivers are mounted.
