1.
2.
INSTALLATION INSTRUCTIONS
4.
3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws.
Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw the holder onto the
attaching plate. Tighten the screw so the holder is firmly in place, but still can be adjusted.
3. To place the device in the holder: Place the upper part of the device in the holder, then flip/press the lower part
forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper
part of the holder, in the same time pull the lower part of the device out from the holder and then lift the device up
and out from the holder.
4. The holder is in place.
2 (2)
