13
IT
ENG
CONTROL FUNCTIONS
Manual Mode
Reset:
• Remove the reset lever from the housing compartment (fig.1)
• Insert the reset lever inside the control pin as far as possible, turning the lever clockwise by 90 degrees, making sure
that the control pin is blocked in the open position (fig.2)
• Now remove the lever from the control pin and replace it in its housing compartmente
Manual closing:
• Press the button highlighted in fig.3
Manual command with electromagnetic circuit breaker
Reset:
• Power up the electromagnet (elec-
trical wiring diagram on page 8)
• Raise the metal lever on the con-
trol unit casing (fig.1)
• Remove the reset lever from the
housing compartment (fig.2)
• Insert the reset lever inside the
control pin as far as possible,
turning the lever clockwise by 90
degrees, making sure that the
control pin is blocked in the open
position (fig.3)
• Now remove the lever from the
control pin and replace it in its
housing compartment
Manual closing:
• Press the button highlighted in fig.4
Electromagnetic closing:
• Disconnect the power to the electromagnet
Manual command with input electromagnet
Reset:
• Raise the metal lever on the control unit casing (fig.1)
• Remove the reset lever from the housing compartment (fig.2)
• Insert the reset lever inside the control pin as far as possible, turning the lever clockwise by 90 degrees, making sure
that the control pin is blocked in the open position (fig.3)
• Now remove the lever from the control pin and replace it in its housing compartment
Manual closing:
• Press the button highlighted in fig.4
Electromagnetic closing:
• Power up the electromagnet