3
MODEL: 911770 / 4000 SERIES
BROIL KING
®
KEG ASSEMBLY INSTRUCTIONS
M5 x 35
(top screws)
M5 x 50
(bottom screws)
bottle opener
tabs
Handle
gasket
FRONT HANDLE
SIDE HANDLE
M5 x 50
Proper assembly of your new BROIL KING
®
KEG will only require a Phillips head screw driver, a ½ inch or 13mm wrench and a buddy (for lifting).
Follow the steps outlined below and it should take approximately 20 minutes to complete. Refer to illustration on page 2 for part(s) identification
and placement positions.
STEP 1:
Remove the Keg’s stand.
STEP 2:
Unlock clasp and open the Keg’s lid. Remove
and unpack all contents and check against parts
inventory list.
STEP 3:
Rotate the cast iron grate out of the locked
position, remove and set aside.
STEP 4:
Attach front handle with Phillips head screwdriver.
M5x50 screws go in the bottom holes with the bottle
opener tabs. M5x35 screws go in the top holes. Silicone
gaskets install behind handle (two places).
STEP 5:
Attach side handles (2) using 4 (M5 x 50)
screws. (Use Phillips head screwdriver)
STEP 6:
Attach both wheels to the axle posts on the
stand in the following order: wheel, washer nut and
hub cap. Use ½ inch or 13mm wrench. Then screw in
leveling feet to stand.
STEP 7:
With everything out of the grill, relock clasp
on the Keg’s lid.
STEP 8:
With one person on each side of the BROIL KING
®
KEG, lift out of the box gripping side and
back handles only. Do not use the front handle to lift the entire grill weight.