11
BCP 6 Burner
Installing the Appliance in a BBQ Island
You will need a second person to help you avoid damaging the appliance or your appliance island.
The island must be made out of non-combustible material. In the event it is combustible, the use of an insulation jacket is
required.
Before installing an appliance in any island cut out, make sure that the opening is not bigger than the outside frame of the
appliance unit. The appliance should rest on the lip of the frame.
Pay careful attention to the location of the gas line. It should be routed away from sources of heat, sharp edges and should
make as few bends as possible.
Check to see if the gas line connection will be accessible when appliance is installed.
If the gas line connection is not easily accessible when the appliance is installed, support the appliance above counter level and
attach the gas line to the appliance. When the gas connection is made, slide the appliance into the cut-out. If the gas line
connection is accessible when the appliance installed, slide the appliance into the cut-out and then attach the gas line.
Be very careful not to kink the gas line when lowering the appliance into the cut out.
Keep your fingers away from where the appliance will be supported on counter. Your fingers could become trapped and serious
injury could occur.
Check to make sure the appliance is level and is supported around the entire outside edge. If the appliance is not level or is
unstable, use non-combustible shims under the outside lip to stabilize it.
Perform the leak test procedure as described earlier in this manual.
BCP600S has no Part#22 (Knob Lamp) and Part#27 (Lamp Switch).
