Prior to cleaning the internal parts, the light must be disconnected from all power sources.
Place the light on its side on a soft surface to prevent damage to the glass. Use the supplied size 6 hex key to remove the
M10 screw from the bottom of the light. Next, tilt the metal cover out and disconnect the ground wire. Thread the screw back
into the hole, turning it 3–4 times. In the next step, the screw will be used to hold the heat sink with light source in the
upright position.
CLEANING / DISASSEMBLING THE LIGHT AND REPLACING THE GLASS 1/3
2.
PAGE 5
Summary of Contents for Dome Nomad
Page 1: ...CM14132...
