C_001 rev.03
12
BROLLO SIET S.r.l. – Via Mazzini, 24 – 31031 CAERANO SAN MARCO (TV) – tel +39.(0)423.657.550 – Fax +39.(0)423.650.337
http//:www.brollosiet.com E-mail: com@brollosiet.com
5.1.
C
OUNT DOWN
/
COUNT UP PARAMETERS SETTING
When the display is in stand or reset modality:
1.
Push the push-button
“2”
for two seconds.
2.
With buttons
“1”
or
“2”
, select the count type:
- UP: forward count
- DOWN: back count.
3.
Push the push-button
“2”
for two seconds (the display will show “O” on the left).
4.
Push the push-button
“1”
or
“2”
to set the hours.
5.
Push the push-button
“2”
for two seconds (the display will show “N” on the left).
6.
Push the push-button
“1”
or
“2”
to set the minutes.
7.
Push the push-button
“2”
for two seconds (the display will show “S” on the left).
8.
Push the push-button
“1”
or
“2”
to set the seconds.
9.
Push the push-button
“2”
for two seconds to prepare the display to the count.
5.2. START/PAUSE
OF THE COUNT DOWN
/
COUNT UP
1.
Push the push-button
“1”
to start the count.
2.
Push again the push-button
“1”
to pause the count.
3.
Push again the push-button
“1”
to start the count again.
Reaching the zero value (or the set value in the case of a count up), the display will stop. It is possible to
start again the count pushing the button “1” for two seconds.
5.3. RESET
AND NEW SETTING OF COUNT DOWN
/
COUNT UP
1.
Push the push-button
“1”
to pause the count.
2.
Push the push-button
“2”
to reset the display.
WARNING !
The count goes on even at turned off display.
If the display is turned off during the pause, it will reset the value when it will be turned on again.
6.
MAINTENANCE
For any maintenance intervention, except for installation and programming, always call BROLLO SIET
technicians.
User is exclusively authorized to the turning on and programming procedures described in this handbook.
7.
SUGGESTION FOR A CORRECT USE
WARNING
For installation, maintenance and internal cleaning, refer to qualified personnel.
Do not overlap any glass or plastic screen to the display screen in order to avoid LEDs overheating.
