31
bromic.com/heat
MAINTENANCE & SERVICING
IMPORTANT NOTES & WARNINGS
For longest product life, and to maintain product appearance, mount heater under cover and
protect from rain and weather whenever possible.
The exterior housing of the heater should be cleaned regularly. To clean the appliance; ensure
heater is off and has been off for at least 2 hours after operation, before wiping off any dirt/dust
with a soft damp cloth.
Salt in the air can cause rusting of metal, especially at locations near the coast. Additional
cleaning of the heater with a soft damp cloth fortnightly will aid in maintaining the product’s
appearance.
Do not clean heater with cleaners that are combustible or corrosive.
MAINTENANCE
WARNING
DANGER
IMPORTANT
This heater MUST be installed by an authorised/ licenced person. Do not perform maintenance,
or carry out installation or assembly procedure while electrical power is switched on.
ELECTRICAL SHOCK HAZARD!
Serious injury or death may occur. Disconnect from electrical
supply before installing or servicing this heater. Read and follow installation clearance
requirements outlined in this manual. The appliance MUST be connected to a properly grounded
electrical source. Isolate mains before installing. Use only with a properly secured heater.
Check product label for correct voltage and wattage to ensure power source conforms to
the heater’s requirements.
Make all connections in accordance with local electrical code regulations. For outdoor
installation, all connections must be made in accordance with local electrical code
regulations for outdoor wiring.
OVERCURRENT DEVICE:
The outputs are NOT protected against short circuits or extra-
currents which can damage the electronic board. Evaluate the characteristics of the
connected loads and apply the appropriate safety devices to the power line.
Check surrounding area of heater for hazards before turning on.
!
!
