16
6. release
6.1 rfs 2 interface (radio frequency system)
Senso power packs are standard-equipped with
a 99-channel RFS 2. Up to 99 devices can be con-
trolled per channel. The antenna is not visible – it
is integrated in the power pack. RFS 2 can be swit-
ched on or off with the "rf" key (4). When RFS 2 is
activated, the blue LED to the right of the "rf" key
will light up. For flash triggering via RFS 2, the
channel of the power pack (studio address) must
correspond to the channel of the RFS 2 transceiver.
The channel (studio address) is defined by pressing
the "aux" key (9) once, followed by the selection of
the channel with the "
q
/
p
" keys (16). By pressing
the „aux“ key (9), the actually set studio address (Stxx) appears in display (15), and the unit number
(Unxx) being currently used appears in display (17). The unit number is not relevant for the release
by RFS 2 (see also 9.1).
The channel and unit selection mode can be exited by pressing the "aux" key several times. Alter-
natively, the Senso will automatically return to the ready mode after about 7 seconds.
6.2 photocell (cell)
The photocell can be switched on or off using the "cell" key (13). If it is activated, the blue LED on
the right, next to the key, lights up.
6.3 sync socket
The broncolor synchronous cables (art. no. 34.111.00
and 34.112.00) may be plugged into the socket (10)
to trigger flashes via cable.
6.4 "test" key
This key (13) allows manual release of the power
pack. Flash release is possible as soon as 70 % of
the set energy is available.
The visual ready signal (13), however, lights up only
when 100 % is available.
