17
7. remote control
The remote control system has 99 channels (studio addresses) with up to 99 unit addresses per
channel. The channels assign each an independent workstation. Each flash unit within a worksta-
tion is identifiable by its own unit address. Every other workstation can each operate up to 99 flash
units. Therefore, flash units of multiple workstations are clearly identifiable (see also 9.1)
Important: the senso rfs 2 interface allows remote flash triggering and only limited remote
control of the flash energy, i.e. only power selectors (16 and 18) can be adjusted (by up to 2.5
f-stops). rocker switches (1 and 2) cannot be remote controlled. the senso can be configured
in such a way that a warning signal sounds when an energy limit has been reached (see section
9.4).
7.1 remote control channels (rfs 2 studio address)
Remote control by means of RFS 2 may be performed via separate channels (studio workstations).
These can be set in the power pack (see section 9.). All flash units within a studio workstation must
have the same channel number (studio address).
7.2 rfs 2 unit addresses
Individual unit addresses can be assigned to each power pack (see section 9.). These are used for
individual control of the flash units by means of PC/MAC. This function is not yet available.
8. dIsplays VIsual/audIble
8.1 the visual ready signal
This is the blue LED at the “test” key (13). It lights
up only when the unit is fully charged or dischar-
ged. After triggering a flash, this LED goes out, and
lights up again when the unit is fully charged once
more. The visual ready signal is easy to read even
in dark rooms due to its bright, blue illumination.
8.2 the audible ready signal
A “beep” tone sounds when 100 % charge is achieved or when the discharge process is finalised.
The signal can be switched on or off.