25
14. lItos lamp
Compact lamp developed especially for Senso power packs with heat-
resistant, fibreglass-reinforced, impact-resistant polyamide case and
integrated pan/tilt head for one-hand operation. Stabilised fan power
supply suitable for 100-240 V mains. The bayonet is identical with that
of other broncolor lamps, providing access to a comprehensive line of
light shapers and accessories.
14.1 multi-functional reflector
The Litos lamp comes with a reflector (or umbrella reflector) that doubles as a protective cover. To
remove the reflector, rotate it anti-clockwise and pull it out of the slot holes. To install the reflector
on the lamp, remove the rubber cap - this can be lifted out of the locking device with a slight pull in
the opposite direction of the arrow-shaped opening. Turn the reflector over and rotate it to secure
it with the bayonet holders in the apertures provided for this purpose. The reflector is securely
mounted when a click is heard.
To remove the reflector, rotate it as far as it will go. Then pull the lever on the upper side of the
lamp to the rear. Rotate the reflector further, anticlockwise, and now it can be pulled out of the
apertures.
attention: for safety reasons, the litos lamp and litos flash tube must be operated only with
senso power packs. the lamp must be fitted with a suitable modelling lamp. for operation with
the supplied reflector, the modelling lamp must have a maximum rating of 300 w.
14.2 modelling light switch
The switch on the lamp is used to switch the modelling light on and off. To avoid damage to the
lamp filament, always switch off the modelling light before moving the lamp.
14.3 replace flash tube
attention: before replacing the flash tube, make sure the lamp plug is disconnected from the
power pack! let the lamp cool down for at least 10 minutes before replacing the flash tube!
The flash tube is a plug-in type.
First, remove the reflector if attached. By turning, carefully pull the protective glass out of the
fastening clips in the axial direction (avoid jamming).
Press the end of the flash tube holder spring down and then press this spring beneath the flash
tube as far in as necessary and hold it there to axially remove the flash tube out of its socket.
