10
3. lamp outlets
Senso power pack has 3 lamp outlets. The flash
energy is divided between them as follows:
Channel 1 over the lamp outlet with the numerical
14.1
Channel 2 over the lamp outlets with the numerical
14.2 and/or 14.3.
Lamp plugs and sockets have a mechanical locking
device to prevent them from accidentally coming
loose. When plugging in, ensure that the front
part of the plug is inserted first, and that the rear
locking device locks completely into place. To re-
lease, press down the locking device spring under the cable guide and lift out the plug from the
socket. The power pack must be switched off whilst plugging in and unplugging.
Each channel is individually controllable (1 and/or 16 or 2 and/or 18). The digital power distribution
displays (15 and 17) indicate the set energy of each individual channel according to the set mode
(symmetry / asymmetry). In symmetry mode, only the upper digital display (15) is lit, in asymmetry
mode both displays are lit (15 and 17).
4. energy control
4.1 Introduction
Senso power packs can be set for symmetric or
asymmetric power distribution by actuating the
"sym/asym" rocker switch (3). Power levels can be
differentiated with rocker switches (1 and 2) as
well as with the illuminated silicone keys "
q
/
p
" (16
and 18). All setting changes are confirmed with an
acoustic signal. In the symmetric mode, the entire
output energy of 1200/2400 joules (Senso A2/Senso
A4) is available at lamp outlet 14.1, 14.2 or 14.3; if
several lamps are connected, the energy is distri-
buted uniformly to all outputs.
The actuation of rocker switches (1 and 2) allows
unneeded capacitors to be bypassed, which reduces
the energy input level.
