a. Press the
MENU
button 4 times, “
VOX
” will be displayed
and
“OF”
flashes on the LCD Screen.
b. Press the
UP
button to set the VOX sensitivity level (the
maximum level is
“
3
”
). To deactivate the VOX function,
press the
DOWN
button until “OF” appears on the LCD
Screen.
c. Press the
PTT
button to confirm your setting. “
VOX
” will
steadily appear on the LCD Screen as along as the VOX
feature is activated.
VOX operation is not recommended if the FX-400 will be used in a
noisy or windy environment.
3.6 Activating the auto Channel and sub-channel Scan
Channel scan perform searches for active signals in an endless loop
for all 8 channels, 38 CTCSS codes and all 83 DCS codes.
a. Press the
MENU
button 5 times
b. Press the
UP
or
DOWN
button to begin scanning
channels when an active signal is detected, channel
scan pauses on the active channel.
c. Press the MENU button again, CTCSS flashes on the
LCD screen press the
UP
or
DOWN
button to begin
scanning CTCSS 1-38.
d. Press the
MENU
button again, DCS flashes on the
LCD screen. Press the
UP
or
DOWN
button to begin
scanning DCS code 1-83.
e. Press the
PTT
button to confirm your setting.
3.7 Vibrator and Call alert
Your FX-400 can alert you to incoming signal by emitting an audible
call tone and vibration signal.
3.8 Call-Ring tone
You can send a Call-ring tone to other PMR users to give an
alert that you want to communicate with them.
Press the CALL button
Yu will hear a ring tone for about two seconds; “
TX
” appears
on the LCD Screen. Any other units within the transmitting
range and turned to the same channel and sub-channel ( if
applicable) will hear the Call-ring tone.
3.9 Selecting a Call- Ring tone
The FX-400 is equipped with 5 different types of Call-Ring tones.
a. Press the
MENU
button 8 times, the LCD Screen will
display Call Icon and blinking.
b. Press the
UP
or
DOWN
button to select the desired
Call-ring tone. A respective Call- Ring tone sound will be
played when changing from one tone to another.
c. Press the
PTT
button to confirm your setting.
3.10 Activating the Vibrator mode
a. Press the
MENU
button 9 times; “0I” flashes on the LCD
Screen.
b. Press the
UP OR DUWN
button to activate the vibrator
function.
3.11 Setting the Roger Beep
The Roger Beep is a tone which is automatically transmitted
whenever the PTT button is released. This alerts the receiving party
to inform that you have intentionally ended the transmission, and you
are now in receive mode.
