Bronkhorst®
Instruction Manual IQ+FLOW® Series Digital Mass Flow / Pressure Controllers for Gases
9.17.045V
2
Copyright
© 2018 Bronkhorst High-Tech B.V.
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means,
without the prior written permission of the publisher.
Disclaimer
This document has been reviewed and is believed to be accurate. Bronkhorst High-Tech B.V. does not assume liability for
errors, inaccuracies or absence of information. The material in this document merely serves information and illustration
purposes; no rights can be derived from its contents.
Bronkhorst High-Tech B.V. reserves the right to modify or improve its products and documentation without informing
anyone. The information contained in this document is subject to change without notice. Device specifications and the
contents of the package may deviate from what is stated in this document.
Symbols
Important information. Disregarding this information could cause injuries to people or damage to the instrument or
installation.
Helpful information. This information will facilitate the use of the instrument and/or contribute to its optimal
performance.
Additional info available on the internet or from your local Bronkhorst representative.
Receipt of equipment
Check the outside package box for damage incurred during shipment. If the box is damaged, then the local carrier must be
notified at once regarding his liability, if so required. At the same time a report should be submitted to your local
Bronkhorst representative.
Carefully remove the equipment from the box. Verify that the contents of the package was not damaged during shipment.
Should the equipment be damaged, then the local carrier must be notified at once regarding his liability, if so required. At
the same time a report should be submitted to your local Bronkhorst representative.
·
Check the packing list to ensure that you received all of the items included in the scope of delivery
·
Do not discard spare or replacement parts with the packaging material
Refer to
Removal and return instructions
about return shipment procedures.
Equipment storage
The equipment should be stored in its original package in a cupboard warehouse or similar. Care should be taken not to
subject the equipment to excessive temperatures or humidity.
