17
2.1.
SPECIFICATIONS ACCORDING TO THE MODEL
2.1.1. LORCA-C
In order to install the model Lorca-C, the fireplace includes a Z-shaped metallic
piece that must be screwed to the wall. This piece will support the weight (
see
drawing D12
).
IMPORTANT!!!: it is necessary to assure that the wall will
support the weight of the fireplace (121 kilos and the weight of
the wood). It is not recommended to install the fireplace on walls
made of materials that are not able to support the weight or
made of combustible materials (see section 4 Safety Measures).
2.1.2.
EBRO AND EBRO-R
This fireplace does not include the draft-diverter valve but, on the top, it includes an oven with a hermetic cooking chamber. The base of
the oven is made of refractory brick (it absorbs heat and irradiates it). Heating is produced when the smoke passes through the sides and
the upper part of the oven. On the ceiling of the oven there is one pipe that connects the cooking chamber with the smoke outlet in order to
remove the gas generated in the oven.
The oven has the following components:
-
Thermometer: it is disassembled and you can find it in the baking tray.
It shows the cooking temperature of the oven. In order to install it, it is
necessary to introduce the sheath through the hole of the door and,
then, put the nut. (
see drawing D13
)
WARNING!! The thermometer shows the cooking temperature of the
oven. It never shows the temperature of the combustion chamber.
The maximum cooking temperature for the oven is 200-230ºC. If the
thermometer shows that the oven reaches a higher temperature, this means that the equipment has been overloaded and this fact will
invalidate the warranty.
-
Tray. It is made of stainless steel. It can be adjustable in two different levels according to the level that we use. In order to avoid the
damage of the tray, it is recommended to extract it outside the oven when it is not being used.
-
Refractory bricks. They are placed on the base of the oven. Their purpose is to absorb heat and irradiate it.
2.1.3. FLORENCIA
To install the Florencia model, please follow the next steps:
- First of all, we will indentify the components of the fireplace (
see drawing
D14
)
- Start the installation screwing the anchoring supports (5) to the wall with
high resistance blocks of 8 mm. The minimum height of the lower part from
the anchoring to the floor must be 600 mm (
see drawing D15
)
- Then put the combustion body (2) to the anchoring supports (1) with the
three lateral screws (a). (
See drawing D16
)
- In third place put the side coating (3) in the body (2) and fix these sides
with the rear screws (
see drawing D17
)
- Put the cornice coating (4) in the ceiling of the body (2) with the screws
(b) (
see drawing D18
)
D12
D13
1: Anchoring support
2: Combustion body
3: Side coating
4: Cornice coating
5: Top coating
6: Cover coating
7: Trim
8: Telescopic
D15
D16
D17
D18
D14
EN
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
METALLIC FIREPLACES
