2022/01/06
FT128 Quick Operation Guide
Page
2
of
6
4 - TO DISABLE (ISOLATE) AN ACTIVE ALARM:
IMPORTANT: Alarm devices must be silenced before pressing “Disable” button.
Press
Button to isolate device in alarm
– system will now illuminate the
LED. This zone / address point will remain disabled until manual re-
enabled via Menu H2/B6 button.
5 - TO DISPLAY MORE THAN ONE ALARM :
When the
Alarms queued
red LED’s are illuminated
. Press the
Button to see the additional Alarms.
6 - TO MANUALLY DISABLE (ISOLATE) AN ALARM POINT FROM THE MENU:
1. Press
b
utton.
2. Key Enter Access Code.
3. Scroll to the
Disable
or re-enable
menu (
H2
) by pressing
or
button/s then press
to
Accept
a. DISABLE SINGLE POINT
i. Scroll to the
Disable address
menu (
B2
) by pressing
or
button/s then
press
to Accept.
ii. Type in the address number as required, then press
to Accept.
b. DISABLE WHOLE ZONE
i. Scroll to the
Disable zone
menu (
B1
) by pressing
or
button/s then press
to Accept.
ii. Type in the address number as required, then press
to Accept.
4.
When prompted with “Re-enable time”:
a. If re-enable time not required, use scroll buttons
or
to highlight
No
o then
press to
Accept.
b. If required, key in the time in hours:minutes (default is current time + 3 Hours), scroll
highlight to
Yes
o then press to
Accept.
5. Press the
Button repeatedly until the menu returns to the date / time screen.
