Installation
Polycold Cryochiller
Route Condensate Drain Tube
Installation and Operation Manual
Brooks Automation
4-26
214072 Revision B
Route Condensate Drain Tube
1.
Locate the condensate drain tube. It is visible from the base of the unit and is visible
when the front skirt and rear skirt are removed. See
.
2.
Determine if the drain tube should be routed to the front or to the rear of the unit.
3.
Be careful to not damage the fitting on the bottom of the drain pan while moving the hose to posi-
tion.
Support the drain pan fitting while carefully moving the drain hose to the desired side of the unit.
4.
When the drain hose is in its final position, check the hose for kinks and adjust as required.
5.
Route the tubing to a facility waste water drain or to the input line of a condensate pump.
6.
Go to the Installation Checklist
.
Initial and date this task. Go to the next task on the check-
list.
Item Description
Electrical Category
Type 1 – Equipment is fully de-energized
Tools Standard
hand
tools
Material
5/16 inch ID tubing
Length is dependent on facility drain location
Condensate Pump Kit (optional)
Figure 4-20: Condensate Drain Tube
External
Condensate
Drain Tube