1.2.9
Fixing Down the Rail
1.
Run the stairlift down to the bottom
of the staircase.
2.
Visually check that the rail is parallel
to the adjacent wall, and looking up
the stairs, behind the seat that the
stairlift will not catch the wall on the
way up.
3.
Also check that there are no
obstructions such as window cills.
There should be approximately 25mm
between seat back and the wall to avoid
trapping hazards.
4.
Adjust the clearance between the stairlift and the wall by moving the
rail in or out appropriately.
5.
Once checked and final position verified,
screw the rail brackets down to the stairs
using the screws provided (four per bracket).
1.2.10
Connecting the Transformer
DO NOT plug the transformer
into the mains socket YET!
The transformer from the fitting kit now
needs to be connected to the charge
system wiring as follows:
1.
Insert the transformer lead through the
hole on the underside of the rail (rubber
-grommit) and out through the end of the
rail.
2.
Pull out the charge point wires and connector block from the end
of the Rail and join the wires from the transformer into the connector
block. The transformer output is AC, either wire can be connected to
either terminal.
3.
Push the jointed wires and connector block back into the rail end,
push the rail end cap from the fitting kit over the end of the rail.
Ensure that the transformer wire is neatly routed so it will not cause
a tripping hazard or get caught by the moving stairlift.
Plug in the transformer only
on completion.
25
����
Summary of Contents for Stairlift
