3
baTTerY replacemenT
Your grill set comes with one clip-on tool light that can be used on any of the three
tools. If grilling tool light appears dim or does not turn on, the batteries may need
replacement.
1. If attached, remove the light from grilling tool.
2. Locate battery access cover on underside of light housing. Battery cover has the
words OPEN, and directional arrows on it.
3. Turn battery cover counterclockwise until it stops against plastic tabs.
4. Lift cover off, or gently tap bottom of light on a flat surface to loosen cover.
NOTe: light contains two Cr1620 button cell batteries. They could come out
during battery cover removal.
5. With old batteries removed, install two new CR1620 batteries.
NOTe: There are no battery polarity markings. Install both batteries with the +,
or side with writing on them, facing UP; facing the battery cover.
6. Install battery cover by aligning cover slots with tabs on light, then turn cover
clockwise until it stops against plastic tabs.
7. Turn light over and test by pressing the On/Off button.