Step 10
Align the base of the draw to the structure and slide
along the grooves until it reaches the end. Repeat for
the remaining draws.
Step 11
Insert a dowel
(J)
into the middle holes on either side
of the front panel of the draw and cam screws
(F)
in
the four outer holes. Fit a washer
(I)
to a screw
(I)
and
screw it into the middle hole on the front panel. Align
the front panel to the structure and press firmly
together. Insert cam locks
(E)
in each of the holes along
the outside of the structure and then cover them with
plastic caps
(P)
. Repeat the for the remaining draws.
I x 5
P x 20
F x 20
E x 20
J x 10
F
I
P
E
