© 2007-2008 Broseley Fires Ltd
THANK YOU FOR PURCHASING A YORK MIDI GAS-FIRED STOVE
Broseley Fires Ltd, a family run company, was founded as a gas appliance design and
development company in 1975.
Since then we have built up an enviable reputation for the quality, reliability and fuel
efficiency of our stoves.
These instructions have been carefully prepared to guide the installer and end-user
through the relevant methods and standards for installation of your new York Midi Gas
Stove. Correctly installed and operated, your Stove will give you many years of warmth
and reliability. Therefore, we would suggest that you read the whole instruction manual
prior to handing it to your installer. That way you will have a clearer picture of what is
involved.
3. IMPORTANT INFORMATION
APPLIANCE TO BE INSTALLED IN ACCORDANCE WITH NATIONAL REGULATIONS
1. The York Midi is a gas stove designed to run on either natural gas or LPG. The
burner units are not interchangeable between the two types of gas. This stove is
a radiant convector fuel-effect appliance. The site of the stove i.e. the chimney,
flue and hearth etc.., must comply with current building regulations and codes of
practice before the stove is installed.
2.
It is required by law that the complete assembly, installation and commissioning
of gas-fired stoves is carried out by a professionally qualified and accredited gas
fitter
listed on the “gas safe” register.
3. DO NOT ATTEMPT TO INSTALL THIS APPLIANCE YOURSELF. Broseley Fires
Ltd take no responsibility for any breach of the legal standards prevailing as far
as the fitting of this appliance is concerned.
4. Warmland Stoves are efficient appliances, giving off convected, conducted and
radiated heat. All services of the stove except the control knob are considered to
be working surfaces. Adequate precautions should always be taken to protect
children, the elderly, the infirm and pets etc. from coming into contact with the
stove.
5. Ensure that the local gas distribution conditions, the nature of the gas pressure
are compatible with the data plate fitted between the right hand legs and on the
control valve
These instructions have been compiled in accordance with BS5258 part 12:1986. The
Gas Safety Installation and Use Regulations 1994. The Building Regulations (issued by
the Department of the Environment). The Building Standards (Scotland)(consolidation)
Regulations
