- Assembling the container, container lid, blender and propulsion cover properly, the safety
switches will release and the appliance may be turned on. The appliance can not be
turned on without the lid, blender or propulsion cover on!
- do not use the safety switch controlled by the container and container lid and the safety
switch controlled by the blender or propulsion cover to turn off the appliance.
- Before removing the lid or container, let the rotating part stop.
- Be careful when handling the accessories, it is very sharp.
- Remove the blade protectors from the knife before use.
- do not process ingredients with temperature higher than approx. 80 °C (170 °f). When
mixing hot liquids pull out the plug d4 from the blender lid.
– When mixing or blending liquids, never use a greater volume than is indicated on the
bowl.
– If the processed foods start to stick to the accessories (e.g.
on the blades or graters
),
turn off the appliance and carefully clean the accessories (e.g. with a spatula).
– Make sure that the power cord does not come into contact with the rotating part of the
appliance.
– The power cord must not be damaged by sharp or hot objects, by an open fl ame and it
must not be submerged under water.
– Never place it on hot surfaces and do not leave it hanging over the edge of a table or a
work bench. If the cord is brushed against or pulled by for example children the appliance
may tip over or be pulled down and lead to serious injuries!
– If the use of an extension cord is necessary, then it must not be damaged and must meet
the valid norms in force.
– If the power cord of this appliance is damaged, the cord must be replaced by the
manufacturer, their service technician or by a similarly qualifi ed person, this will prevent
the creation of a dangerous situation.
– Only use the appliance with original accessories from the manufacturer.
– Use this appliance only for the purpose for which it was designed as specifi ed in this
user‘s manual. Never use the appliance for any other purpose.
– The manufacturer takes no responsibility for damages and injuries caused by the
incorrect use of supplementary machines and accessories (e.g.
ruining of foods, injury,
cuts
) and takes no responsibility arising from the warranty on the appliance in the case
that the above safety notices were not followed.
II.
FEATURES OF THE DEVICE AND ACCESSORIES (pic. 1)
A - propulsion unit
A1 – ON / Off button
A6 – propulsion shaft
A2 – PUlSe button
A7 – blender shaft
A3 – revolution regulator
A8 – space for storing the supply cord
A4 – safety switch
A9 – supply cord
A5 – safety switch
A10 – propulsion cover (activates and deactivates the
safety switch)
B - container
(activates and deactivates the safety switch)
C – lid
C1 – safety protrusion (activates and deactivates the safety switch)
C2 – feeding opening
D - blender container
(activates and deactivates the safety switch)
d1 – rubber seal
d3 - lid
d2 - knife
d4 – lid plug
60
GB
