Control panel
3 - 5
3
Service call indications
If there is an error that cannot be cleared by the user, the printer will show that a service call is needed by
lighting up all the LEDs as shown below.
If you see the service call indication above, turn off the power switch, wait a few seconds, and then turn it
back on and try to print again.
If you cannot clear the error and see the same service call indication after turning the printer back on, call
your dealer or a Brother authorized service representative.
When you press the
Go
button, the LEDs will light up as shown in Table 1. See
Table 1: LED indications while
on page 3-6 to identify the error.
For example, the LED indication below shows a fuser unit failure.
