1 - 4 INTRODUCTION
NC9100h_FM6.0
<Bottom>
■
Ethernet Address (MAC Address)
The Ethernet Address of the device. An Ethernet Address is
sometimes referred to as a MAC Address.
<Right Side>
■
NC-2200w (USB Port)
Connect a USB cable (Type A) here.
■
Power Connector
Connects to the AC adapter.
<Front face>
Test Button
How to Print a Network Configuration Page
To print the Network Configuration Page, press the Test Button of the
NC-2200w.
How to Reset to Factory Default Setting
If you wish to reset the NC-2200w back to its default factory settings
(resetting all information such as the wireless settings, password and
IP address), hold down the Test Button for more than 10 seconds.
Do not turn the NC-2200w power switch off during factory
default setting.
A
B
(Up to 6 feet or 2 m)
