CARE AND MAINTENANCE
200
Cleaning the Cutter in the Bobbin
Case Area
The cutter below the needle plate should be
cleaned. If dust or lint accumulate on the cutter, it
will be difficult to cut the thread when the “Thread
Cutter” button is pressed or the automatic thread
cutting function is used. Clean the cutter when the
thread is not easily cut.
a
Follow steps
a
through
g
in “Cleaning the
Race” to remove the needle plate.
b
Use the cleaning brush or a vacuum cleaner
to remove any lint and dust from the cutter
in the bobbin case area.
a
Cutter
c
Attach the needle plate.
About the Maintenance Message
Once this message appears, it is recommended to
take your machine to an authorized Brother dealer
or the nearest Brother authorized service center for
a regular maintenance check. Although this
message will disappear and the machine will
continue to function once you press
, the
message will display several more times until the
appropriate maintenance is performed.
Please take the time to arrange for the
maintenance your machine requires once this
message appears. Such steps will help to ensure
you receive continued, uninterrupted hours of
machine operation for the future.
CAUTION
• Do not touch the cutter, otherwise injuries
may result.
a
Summary of Contents for 882-W30
