KNOWING YOUR SEWING MACHINE
10
Changing the needle stop position
Normally, the sewing machine is set to leave the
needle in the fabric when sewing is stopped. Instead,
the machine can be set to leave the needle raised
when sewing is stopped.
1
Turn off the sewing machine.
2
Holding the “–” side of (
1
) pressed, turn
on the sewing machine.
3
After the sewing machine has turned on,
release the “–” side of (
1
).
X
The needle stop position changes to the
raised position.
Memo
• Perform the same operation to change the needle
stop position to the lowered position.
Changing the initial needle position
Normally, the straight stitch (left needle position) is
automatically selected when the sewing machine
is turned on. The initial needle position can be
changed to the straight stitch (center needle position).
1
Turn off the sewing machine.
2
Holding the “+” side of (
2
) pressed, turn
on the sewing machine.
3
After the sewing machine has turned on,
release the “+” side of (
2
).
X
The initial needle position changes to the
center needle position.
Memo
• The specified initial needle position is maintained
after the machine is turned off.
• Perform the same operation to change the initial
needle position to the left needle position.
Cancelling the operation beep
When the sewing machine is purchased, it is set to
beep each time a key is pressed. This setting can be
changed so that the machine does not beep.
1
Turn off the sewing machine.
2
Holding the “–” side of
(
3
) pressed,
turn on the sewing machine.
3
After the sewing machine has turned on,
release the “–” side of
(
3
).
X
The machine is now set so that it will not
beep.
Memo
• Perform the same operation to change the setting
so that machine beeps.
THREADING THE MACHINE
Winding the bobbin
This section describes how to wind the thread onto
the bobbin.
• For details on the fast bobbin winding, see page
13.
1
Bobbin-winding thread guide
2
Bobbin winder shaft
3
Bobbin
Summary of Contents for 885-E33
Page 2: ......