Embroidering Preparation
29
EMB
R
OI
DE
R
Y
2
Attaching the embroidery frame
a
Raise the presser foot lever to raise the presser foot.
b
Pass the embroidery frame under the presser foot.
• If necessary, raise the presser foot lever even further.
c
Firmly insert the embroidery frame guide into the
embroidery carriage frame holder from the top.
Line up the embroidery frame guide tabs and the
embroidery carriage frame holder slots and push in until
it clicks and stops.
1
Embroidery frame guide tabs
2
Embroidery carriage frame holder slots
The embroidery unit is attached.
■
Removing the embroidery frame
a
Raise the presser foot lever to raise the presser foot.
b
Press the part of the embroidery carriage frame holder
in the figure to the left side, and raise the embroidery
frame.
The embroidery frame will separate from the
embroidery carriage frame holder.
c
Remove the embroidery frame under the presser foot
while raising the presser foot lever even further.
Note
• Wind and insert the bobbin before attaching the
embroidery frame making sure to use the
recommended bobbin thread. Check that there is
enough thread in the bobbin.
CAUTION
• Correctly set the embroidery frame into the
embroidery carriage frame holder. Otherwise,
the presser foot may hit the embroidery frame,
resulting in injury.
a
b
1
Lever
CAUTION
• Do not hit the needle with your finger or the
embroidery frame. It may cause injury or
needle breakage.
a
Summary of Contents for 888-P30
Page 2: ......
