26
Installing and Uninstalling the Holder
After adjusting the blade extension, install the holder
in the machine. For the blade extension appropriate
for the material, see “Adjusting the Blade Extension”
on page 24.
a
Press
in the operation panel to turn on the
machine.
For details, see “Turning On/Off the Machine” on
page 15.
b
If the holder lock lever is not raised, raise it.
The holder cannot be installed if the lever is lowered.
a
Holder lock lever
CAUTION
•
Please remove protective cap from blade
holder before placing it into the machine
carriage.
•
Do not allow infants/children to put the
protective caps in their mouths.
c
Grasp the holder grip, and then insert the
holder into the carriage.
a
Grip
d
Push down on the holder lock lever.
Firmly push down until the holder is locked in place.
e
Reverse the installation procedure to uninstall
the holder.
CAUTION
• After removing the blade holder from the
machine, be sure to retract the blade into the
holder and attach the protective cap.
• Do not leave the blade extended. Otherwise,
injuries may result.
• Do not allow infants/children to put the
protective caps in their mouths.
a
a