61
4
DesignNCut Manager Error
Cannot find SSID. Press [OK] button.
As shown below, the cause and solution differ depending on when this
message appeared.
- Appeared after running [2.Setup Wizard] to search for an SSID
Possible Cause: Failed to detect an SSID
Solution: Check the information described for 1. of (Err-02).
- Appeared when [Saved SSID] is selected in the window listing the
detected SSIDs
Possible Cause: There is no SSID previously connected to the wireless
network.
Solution: Select an SSID that appeared in the window, and then set up a
wireless connection.
PC connection error. Press [OK] button.
Failed to connect to the computer when setting up the wireless
connection using the dedicated application “WLAN Assistant Wizard”
(WAW).
Check the following, and then try performing the operation again.
- Start up WAW on the computer, and then follow the on-screen
instructions to complete the procedure.
- Check that a wireless network connection has been established between
the computer running WAW and the access point/router.
WLAN connection failed. Press [OK] button.
Failed to set up the wireless connection using the dedicated application
“WLAN Assistant Wizard” (WAW <USB>).
Check the following, and then try performing the operation again.
- Start up WAW <USB> on the computer, and then follow the on-screen
instructions to complete the procedure.
- Check that the machine and computer are connected with a USB cable.
- Check the possible causes and solutions for (Err-01) to (Err-05) and for
(Err-20).
Network error. Turn the machine off, then on
again.
An internal malfunction occurred.
Contact the retailer where you purchased this machine or the nearest
authorized service center.
Error Code
(Cutting
Machine)
Error Messages (DesignNCut Manager)
Causes / Solutions
E002
DesignNCut is unavailable while it is
connecting to another DesignNCut
Manager. To cancel the connection, restart
DesignNCut.
Turn off the machine, turn it on again, and then make the
connection again.
E003
Cannot connect to machine.
Select an appropriate connection mode for
the settings on DesignNCut.
Select the same connection method as that selected on the
machine.
For details on selecting the same connection method as
that on the machine, see “CONNECTING THE MACHINE
AND COMPUTER” on page 12.
E004
The version of machine and DesignNCut
Manager doesn’t match.
Confirm the versions and update.
DesignNCut Manager and the machine’s software must be
updated. (P. 66)
E204
No pattern in the effective area.
There is no pattern(s) to be cut out or drawn within the
cutting area.
Edit the pattern in ScanNCutCanvas to position it within the
cutting/drawing area.
E207
Attach an appropriate holder.
A holder incompatible with the mode has been installed.
Install a compatible holder. (P. 34)
E217
Data cannot be read on DesignNCut.
The file size is too big.
The data file is too large. Simplify the pattern in
ScanNCutCanvas to reduce the data to 1 MB or less.
E218
Cannot continue as the data has too many
objects.
There are too many patterns. Reduce the number of
patterns in ScanNCutCanvas to 300 or less.
Error Messages (Cutting Machine)
Cause/Solution
