Chapter 1 Machine Preparation
BAS-6150
24
4-7. Retention of upper and lower threads
1.
Press the "FEED" key
q
to move the
carriage feed to the feed position.
50mm
1459S
1458S
1457S
q
4.
Close the slide plate.
5.
By pressing down the "NDL. THREAD CUT"
key
e
, place two upper threads
u
onto
upper thread trimmer knife
i
.
6.
By releasing the "NDL. THREAD CUT" key
e
, revert the upper thread trimmer knife.
7.
Press the "FEED" key
q
to move the
carriage feed to the standby position.
* When the setting for the memory switch 3 (environment
parameter No.63) is set to ON, press the "ENTER" key
r
with the "FEED" key
q
being pressed.
2.
Open the slide plate.
3.
Cover the bobbin with the bobbin case.
Place them into the rotary hook, leaving the
end of the thread
t
out about 50 mm and
pull down the nipper.
Pull up each lower thread through a thread
hole and press "BBN. THREAD CUT" key
w
to retain the threads.
(Note) Pay enough attention not to touch center knife
y
.
w
t
y
e
u
r
i
Summary of Contents for BAS-6150
