4
BAS-6150
If safety devices are once detached, re-attach
them to the original position. Make a check to
confirm that they are in proper function.
Loss and others due to remodeling the ma-
chine are excluded from the scope of warranty.
Do not put scissors, needles, threads, tools
on the table when the machine is set upright.
Falling down of them may cause damage to
the machine or injury to human body.
Ask your Brother dealer or a qualified techni-
cian for electrical maintenance and inspection.
Be sure to turn off the power switch when the
machine is raised. Unintended press on the
foot switch may cause injury.
Turn off the power switch and pull off the plug
by holding not of the cord but of the plug for
the following occasions. Otherwise, unin-
tended press on the foot switch may cause
injury.
• maintenance, adjustment, and repairment
• replacement of consumable parts such as
the rotary hook, knife, lamp, etc
When adjustment has to be done with the
power switch and air supply on, pay enough
attention to safety. Detach the air tube of air
source and set the pointer of the pressure
gauge to [0] for inspection, adjustment, and
repair of air using devices.
Maintenance and inspection
Turn off the power switch before cleaning.
Unintended press on the foot switch may
cause injury.
Disconnect the air hoses from the air supply
and wait for the needle on the pressure gauge
to drop to "0" before carrying out inspection,
adjustment and repair of any parts which use
the pneumatic equipment.
Be sure to wear protective goggles and
gloves when handling lubricating oil or
grease so that no oil or grease gets into your
eyes or onto your skin. Do not eat or drink
lubrication oil or grease in order not to have
vomiting or diarrhea. Keep oil and grease out
of the reach of children.
Cleaning
Summary of Contents for BAS-6150
