Chapter 7 Environment setting
BAS-6150
79
Not trimmed
Trimmed
Selection is made to decide the lower thread be cut at the
last stitch. When set to OFF, the lower thread is trimmed as
the clamp is moving to the corner knife position.
0 to 70 mm
Distance from the end of sewing to the lower thread knife’s
operation when [No. 26 The last stitch trimming] is set to
OFF.
The lower thread is trimmed as the clamp is moving to the
corner knife position.(This setting is performed to adjust the
amount of the remained lower thread.)
0.0 to 9.9 second(s)
Time from T-gauge descent to the folding plate ON when
the cloth setting is performed.
0.0 to 9.9 second(s)
Time for the start of next operation after the folding plate
ON.
Not used
Used
Setting is performed as to stop the operation by the cloth
sensor at the time of roller driving. The direction of rotation
is specified by symbols for the roller driving distance.
The roller stops with OFF
→
ON (ON edge).
The roller stops with ON
→
OFF (OFF edge).
These are conditions to top the roller when the roller cloth
sensor is used.
0.1 to 9.9 second(s)
0.1 to 9.9 second(s)
Immediate stop "0"
Stop at the end of sewing position "1"
0.1 to 9.9 second
Standby time for the start of the clamp’s movement after the
flap clamp ON.
30.0 to 40.0mm
NO.
Item
Display
Contents (configurable values)
26
27
28
29
30
31
32
33
34
35
36
37
0
0.1
0.2
—
0.5
0.5
1
0.2
35.0
Initial
value
Not used
Only left used
Only right used
Both used
Lower thread last stitch
trimming
Distance to operate the
lower thread knife
Folding plate ON timing
Standby timer after the
folding plate ON
Folding plate operation at
single welting
Setting for the roller cloth
sensor
Roller cloth sensor opera-
tion
Time to rotate after the
roller down
Time to go up after the
roller stops rotating
Operation after the thread
breakage
Timer for standby time
after the flap clamp ON
Flap sensor and needle drop
distance - start of sewing
Summary of Contents for BAS-6150
