37
3
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
buttonhole will not be sewn with the correct
size.
a
Do not reduce the gap.
f
Pull down the buttonhole lever as far as
possible.
a
Buttonhole lever
The buttonhole lever is positioned behind the
bracket on the buttonhole foot.
a
Buttonhole lever
b
Bracket
g
Gently hold the end of the upper thread in
your left hand, and then start sewing.
X
Once sewing is completed, the
machine automatically sews
reinforcement stitches, then stops.
h
Raise the presser foot lever, remove the
fabric, and cut the thread.
i
Raise the buttonhole lever to its original
position.
j
Insert a pin at the end of the buttonhole
stitching to prevent the stitching from being
cut, and then use a seam ripper to cut towards
the pin and open the buttonhole.
a
Seam ripper
b
Pin
For keyhole buttonholes, use a commercial
eyelet punch to make a hole in the rounded
end of the buttonhole, and then use the seam
ripper to cut open the buttonhole.
a
Eyelet punch
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
Memo
●
Before sewing buttonholes, check the stitch
length and width by sewing a trial
buttonhole on a scrap piece of fabric.
●
When opening the buttonhole with the seam
ripper, do not place your hands in the cutting
direction, otherwise injuries may result if the
seam ripper slips.
1
2
1
CAUTION
