13
4
Set the power supply switch on the left side of the printer to “|” to turn on
the copyboard.
Feeding the copyboard
The copyboard has two writing surface areas. When you wish to use the other writing
surface area, press
f
to scroll the writing surface without printing.
b
Do not try to erase or touch the writing surface while it is moving.
Do not touch the paper being fed out of the printer until it has finished feeding.
Writing & printing
1
Make sure that the power supply switch on the left side of the printer is
set to “|”.
2
Write within the scannable area shown in the illustration below.
b
Only use the enclosed Dry Erase markers or markers of the same type. The
use of non-erasable markers will void the warranty.
Do not allow the seam of the writing surface to become dirty.
0.44 in.
(11 mm)
0.44 in.
(11 mm)
0.12 in.
(3 mm)
0.12 in.
(3 mm)
1
3
2
4
3. Operation