20
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
MAKING AN EMBROIDERED APPLIQUÉ FROM A ONE-POINT PATTERN
CONTENTS
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
INDEX
Chapter 6
7
When the machine is finished
embroidering, it automatically stops and
the screen shown at the right appears.
8
Remove the thread cartridge.
The design frame moves back to its starting point
so it can be removed. After the final animation is
displayed, the screen shown at the right appears.
9
Pull out the design frame. Then, take the
pre-cut design fabric out of the frame.
●
●
6.
Selecting the next operation
To embroider the same pattern again
Press the
key until
is highlighted, and then press the
key. The screen shown on
page 13 under
Inserting the thread cartridge and design frame
appears. Repeat the steps to
embroider the same pattern.
To save the pattern
Press the
or
key until
is highlighted, and then press the
key. For more details,
see the section
Saving a pattern
on page 34.
To embroider a different pattern
Press the
key until
is highlighted, and then press the
key. The screen shown on
page 11 under
Selecting the pattern
appears. Repeat the steps to embroider a different pattern.
To finish using the machine
Press the
key.
Key information
•
To skip the animation, press any key.
CAUTION
•
Be sure to follow the correct procedure for removing the thread cartridge before
removing the design frame, otherwise the stitching may be damaged. (See the section
Removing the thread cartridge
on page 15 and
Removing the design frame
on page 17.)
Finished embroidery