HE-800B
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
35
5-4-1. Parameter list
・
Parameters that are not applicable to a particular program will be skipped and not displayed.
・
The allowable setting range for some parameters may vary from the range specified, depending on the settings of
other
parameters. (Refer to “5-4-4. Main restrictions when setting parameters”.)
No.
Setting items
Setting range
Unit
Initial value
Sewing pattern
1-20: Buttonhole stitch
21: Straight tack stitch
1: Rectangle
2: Radial
3: Round
4: Radial-rectangle
5: Round-rectangle
6: Eyelet-rectangle
7: Rectangle-radial
8: Round-radial
9: Eyelet-radial
10: Rectangle-round
11: Radial-round
12: Eyelet-round
13: Rectangle-taper tack
14: Radial-taper tack
15: Round-taper tack
16: Eyelet-taper tack
17: Rectangle-tack
18: Radial-tack
19: Round-tack
20: Eyelet-tack
01
21: Straight bar tack
1 1
02
Length of the hole (cutter length)
4.0–32.0 mm
However, it must be less than
the sewing area.
0.1 13.0
(*1)
03
Correction of cutter X position
-0.50–0.50 mm
0.05 0.00
04
Cutter X space
-0.40–1.00 mm
0.05 0.40
(*1) If the work clamp dimensions have been set to 5.4x19 mm, the initial value for the length of the hole will be 6.0 mm.