7. ADJUSTMENT
HE-800B
105
7-13-3. Adjusting the lower thread clamp opening timing
1. Loosen the set screw (2) of the feed arm support (1), and then align reference line A of feed guide shaft B (3) with the edge
of the feed arm support (1).
2. When the feed mechanism moves by 6 - 7 mm, the opening plate (4) moves and the lower thread clamp (5) opens.
3. To change the opening timing, loosen the set screw (2) and move the feed guide shaft B (3) to the left or right to adjust.
* The end of the thread which is being held by the lower thread clamp (5) is wound around inside the seam. If the opening
timing is too early, it can cause problems such as poor winding or pulling-up of the lower thread. If the opening timing is
too late, it can cause problems such as stretching, uneven seams or bird’s nests at the sewing start, depending on the
type of material.
Note:
After moving the lower thread trimmer cam lever (6) back in the direction of the arrow, move the feed mechanism.
If the feed mechanism is moved when the lower thread trimming has been carried out, the mechanisms will press
against each other, which may result in damage to the lower thread clamp (5) and the opening plate (4).
4349Q
4348Q
4347Q
0752D
Approx.
6 – 7 mm
Sewing start
Lower thread winds around seam
Lower thread releases from
lower thread clamp
Summary of Contents for HE-800B
