HL-6050/6050D/6050DN SERVICE MANUAL
2-1
CHAPTER 2 INSTALLATION AND BASIC OPERATION
1. CONDITIONS REQUIRED FOR INSTALLATION
1.1 Power
Supply
•
The source voltage must stay within ±10% of the rated voltage shown on the rating plate.
•
The power cord, including extensions, should not exceed 5 meters (16.5 feet).
•
Do no share the same power circuit with other high-power appliances, particularly an air
conditioner, copier or shredder. If it is unavoidable that you must use the printer with these
appliances, it is recommended that you use an isolation transformer or a high-frequency
noise filter.
•
Use a voltage regulator if the power source is not stable.
1.2 Environment
•
Make sure that the power outlet/socket is near the printer and is easy to get to so that, if
there is an emergency, it can be easily unplugged.
•
The room temperature is maintained between 10°C and 32.5°C. The relative humidity is
maintained between 20% and 80%.
•
To avoid ozone building up, put the printer in a large well-ventilated room.
•
Place the printer on a flat, horizontal surface.
•
Keep the printer clean. Do not put the printer in a dusty place.
•
Do not put the printer where the ventilation hole of the printer is blocked. Keep a gap of
approximately 100 mm (4 inches) between the ventilation hole and the wall.
•
Do not put the printer in direct sunlight. If you have to put it near a window, use a blind or a
heavy curtain to protect the printer from direct sunlight.
•
Do not put the printer near devices that contain magnets or generate magnetic fields.
•
Do not subject the printer to strong physical shocks or vibrations.
•
Do not expose the printer to open/naked flames or salty or corrosive gasses.
•
Do not put objects on top of the printer.
•
Do not put the printer near an air conditioner.
•
Keep the printer horizontal when you carry it.
