5-46
Confidential
1.3.23 Setting by country (Function code 74)
<Function>
This function is used to customize the machine according to language, function settings, and
worker switch settings.
<Operating procedure>
Model without touch panel
Model with touch panel
(1) Press the
or
key to display
“MAINTENANCE 74” on the LCD in the
initial state of the maintenance mode.
Then, press the
OK
key. The present
spec code is displayed on the LCD.
(The first digit is blinking.)
(2) When you press the
OK
key, the
blinking cursor moves from the first digit
to the second digit.
(The first digit cannot be selected.)
(3) Press the
key to enter “1” and press
the
key to enter “0” and press the
OK
key. When the second digit is
entered, the blinking cursor moves to
the fourth digit.
(4) When you press the
or
key, the
third digit and the fourth digit are
changed at the same time. Display the
relevant numeric value on the LCD and
press the
OK
key.
(5) When you press the
Go
key, the new
setting is saved, and “PARAMETER
INIT” is displayed on the LCD. After the
setting is saved, the machine returns to
the initial state of the maintenance
mode.
(1) Press the
7
and
4
keys in this order in
the initial state of the maintenance
mode. The present spec code is
displayed on the LCD.
(2) Enter the desired spec code (fourth
digits).
(3) When you press the
Mono
key, the new
setting is saved, and “PARAMETER
INIT” is displayed on the LCD. After the
setting is saved, the machine returns to
the initial state of the maintenance
mode.
Note:
If there is a pause of more than one minute, the machine will automatically return to the
initial state of the maintenance mode.
