2-27
Confidential
Self-
Diagnostic
Turn the power off,
then on again.
Leave the machine
for 15 min.
Some fuser unit errors occurred
at power-ON or upon recovery
from sleep mode.
Will Automatically
Restart within 15
minutes.
After the error was detected at
the fuser unit, power was turned
ON again and the error is being
checked. (If power is turned OFF
and ON after error code 6901
occurred, this code is displayed
for about 15 minutes.)
Short paper
Open the Back
Cover and then
press Go.
The registration rear sensor
detected that the paper loaded in
the paper tray was smaller than
the specified size.
Size Error
Specify the correct
paper size for Tray
1.
For printing by feeding paper
from the paper tray 1, the size of
paper specified from the driver
set the size which was not
supported by the paper tray 1.
Specify the correct
paper size for Tray
2.
For printing by feeding paper
from the T2 paper tray unit, the
size of paper specified from the
driver set the size which was not
supported by the T2 paper tray
unit.
Size Error
DX
Press Cancel.
Specify the correct
paper and load the
same size paper as
the Printer driver
setting.
For 2-sided printing, the tray
whose paper size was not
supported by 2-sided printing
was selected.
Specify the correct
paper and press
Go.
The registration rear sensor
detected that the fed paper was
larger or smaller than the
specified size in 2-sided printing.
Error Message
State
Error
Codes
Refer
to:
1st line
2nd line
