4 - 16
Adjustment
BH lever switch position
1. Raise the presser foot lever.
2. Extend the BH presser foot maximum, back it 2 clicks. (Fig. 1)
3. Attach the BH presser foot.
4. Turn the pulley by hand, and down the feed dog lower than the needle plate.
5. Lower the presser foot lever after checking the clearance between the BH presser foot A and the BH presser foot
B is 0.5mm. (Fig. 2)
6. Lower the BH lever, and set it to the BH presser foot.
7. Rotate the BH eccentric shaft and adjust the BH 0 touches the BH 1. (Fig. 3).
*Key point
• Pull the BH presser foot forward as much as possible, and the BH 0 touches the BH 2 and the BH 2 bows a
little bit (Fig.4).
• Pull the BH presser foot backward as much as possible, and the BH 0 touches the BH 1 and the BH 1 bows a
little bit (Fig.5).
Extend fully and
return two clicks
Two clicks
BH presser foot B
BH presser foot A
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Summary of Contents for HS-3000
