3 - 9
Main parts
Main unit
Assembly
10
Feed unit assy. attachment
1. Fit the feed unit
1
to the rear cover assy. attachment position, and secure
them with the 2 screws
1
.
2. Fit the lower shaft bushing
2
to the rear cover assy. attachment position,
set the lower shaft bearing presser
3
, and secure them with the 2 screws
2
.
*Key point
• Set the lower shaft bearing presser
3
so that the projecting
part of
3
is positioned at upper right.
3. Apply 1 or 2 drops of OILER to the matching section of the lower shaft
4
and the lower shaft bushing
2
.
Apply OILER to the matching section of the lower shaft
and the lower shaft bushing.
1 - 2 drops
XZ0206***
1
Torque
1.18 — 1.57 N
·
m
2
Torque
1.18 — 1.57 N
·
m
1
1
2
3
2
4
Giza Tite
5X16
Giza Tite
5X16
11
Spring attachment
1. Attach the spring
1
to the positioning hole
2
of the lower shaft bearing
presser
3
and the notch part
4
of the base plate assy.
2
1
3
1
4
Summary of Contents for HS-3000
