Chapter 7
58
Note
If you have problems receiving faxes,
reduce the ring delay setting on your
external TAD.
Connections
7
The external TAD must be plugged into the
back of the machine, into the jack labeled
EXT. Your machine cannot work properly if
you plug the TAD into a wall jack (unless you
are using Distinctive Ring).
a
Plug the telephone line cord from the
telephone wall jack into the back of the
machine, in the jack labeled LINE.
b
Plug the telephone line cord from your
external TAD into the back of the
machine, in the jack labeled EXT. (Make
sure this cord is connected to the TAD at
the TAD’s telephone line jack, and not
its handset jack.)
c
Set your external TAD to four rings or
less. (The machine’s Ring Delay setting
does not apply.)
d
Record the outgoing message on your
external TAD.
e
Set the TAD to answer calls.
f
Set the Receive Mode to
External TAD
. (See
Recording an outgoing
message (OGM)
7
a
Record 5 seconds of silence at the
beginning of your message. This allows
your machine time to listen for fax tones.
b
Limit your speaking to 20 seconds.
c
End your 20-second message by giving
your Fax Receive Code for people
sending manual faxes. For example:
“After the beep, leave a message or
send a fax by pressing
l
51
and
Start
.”
Note
We recommend beginning your OGM with
an initial 5 second silence because the
machine cannot hear fax tones over a loud
voice. You may try leaving out this pause,
but if your machine has trouble receiving,
then you should re-record the OGM to
include it.
Special line considerations
7
Roll over telephone lines
7
A roll over telephone system is a group of two
or more separate telephone lines that pass
incoming calls to each other if they are busy.
The calls are usually passed down or “rolled
over” to the next available telephone line in a
preset order.
Your machine can work in a roll over system
as long as it is the last number in the
sequence, so the call cannot roll away. Do not
put the machine on any of the other numbers;
when the other lines are busy and a second
fax call is received, the fax call would be
transferred to a line that does not have a fax
machine.
Your machine will work best on a
dedicated line.
Summary of Contents for MFC 8890DW - B/W Laser - All-in-One
