PD-9810
E-3
Chapter 1 INTRODUCTION
(9) [SHORT CUT] key (16 keys)
・
[Sewing speed] key
Pressing this key will show the setting screen for the sewing speed of the machine.
・
[Eyelet pattern] key
Pressing this key will show the setting screen for the eyelet pattern.
・
[Button hole length] key
Pressing this key will show the setting screen for the button hole length.
・
[Taper length] key
Pressing this key will show the setting screen for the taper length.
* When a machine with the straight bar tack specifications is connected, the setting
screen for the straight bar tack length will be displayed.
・
[Offset] key
Pressing this key will show the setting screen for the offset of the taper bar.
* When a machine with the straight bar tack specifications is connected, the setting
screen for the straight bar tack needle number will be displayed.
・
[Stitch pitch] key
Pressing this key will show the setting screen for the stitch pitch in straight section.
・
[No. of eyelet stitches] key
Pressing this key will show the setting screen for the number of eyelet stitches.
・
[Cutting space] key
Pressing this key will show the setting screen for the cutting space.
・
[Knife X position compensation] key
Pressing this key will show the setting screen for the compensation of knife X positions.
・
[Knife Y position compensation] key
Pressing this key will show the setting screen for the compensation of knife Y positions.
・
[Start tying stitches] key
Pressing this key will show the setting screen for the number of start tying stitches.
・
[End tying stitches] key
Pressing this key will show the setting screen for the number of end tying stitches.
・
[X alignment] key
Pressing this key will show the setting screen for the X alignment.
・
[Y alignment] key
Pressing this key will show the setting screen for the Y alignment.
・
[
θ
1 alignment] key
Pressing this key will show the setting screen for the alignment of
θ
1.
・
[
θ
2 alignment] key
Pressing this key will show the setting screen for the alignment of
θ
2.
(10) [
] key
The key is used to select icons and move the cursor.
Summary of Contents for PD-9810
