Changing the Printer Settings
82
3
5 Left Margin
Specifies the left margin.
Available settings: [
Use Paper Size
], [
Columns
]
6 Right Margin
Specifies the right margin.
Available settings: [
Use Paper Size
], [
Columns
]
7 Default Pitch
Specifies character width.
Available settings: [
10 characters/inch
], [
12 characters/inch
], [
15 characters/inch
], [
Proportional
]
8 CR-LF Mode
Specifies how the printer responds when LF (line feed) and CR (carriage return) commands (ASCII
characters 10 and 13) are received.
Available settings: [
LF=LF CR=CR
], [
LF=CR+LF CR=CR+LF
]
9 Roll Printer Case Setting
Specifies the setting for using the optional roll printer case. If [
On
] is selected, you can adjust the feed
value or amount of paper retraction for the roll printer case.
Available settings: [
On
], [
On (Without Anti Curl)
], [
On (Short Feed)
], [
Off
]
10 Print Length Scaling
Specifies the reduction or enlargement ratio for printing.
Available settings: 95% - 105% (in increments of 0.5%)
11 Tear Adjust
Adjust the tear bar tear off position for paper media.
Available settings: [
+0.08"
], [
+0.06"
], [
+0.04"
], [
+0.02"
], [
0"
], [
-0.02"
], [
-0.04"
], [
-0.06"
], [
-0.08"
]
([
+2.0 mm
], [
+1.5 mm
], [
+1.0 mm
], [
+0.5 mm
], [
0 mm
], [
-0.5 mm
], [
-1.0 mm
], [
-1.5 mm
], [
-2.0 mm
])
12 Form Feed Mode
Specifies how the printer responds to form feed commands received from any source.
Available settings: [
No Feed
], [
Fixed Page
], [
End of Page
], [
End of Page Retract
]
13 Paper Grip Time
Specifies the delay before the printer grabs the paper.
Available settings: [
0.5 seconds
], [
0.8 seconds
], [
1.2 seconds
]
14 Pre-Feed
If [
Enable
] is selected, the printer ejects a short length of paper when the printer turns on. When using
perforated roll paper or roll paper that is pre-printed, we recommend setting this parameter to [
Disable
].
Available settings: [
Enable
], [
Disable
]
15 Skip Perforation
Leaves a one-inch (25.4 mm) margin at the top and bottom of the paper. Use it when printing on perforated
roll paper so that the printer does not print on the perforation.
Available settings: [
Enable
], [
Disable
]
