10
3)
Turn the power supply button of the PT-9500PC ON.
4)
Click the “Setting...” button on the screen shown in Fig. 1. The screen shown in Fig. 2 is
displayed.
5)
Select “COM 1” in the COM Ports list box, and “115200” in the Baud-rate list box in the
Setting screen shown in Fig. 2. Then click the OK button. This screen returns to the
screen as shown in Fig.1.
Fig. 2
6)
Then, click the EEPROM Reset button.
7)
Turn the power supply button of the PT-9500PC OFF.
8) Turn the power supply button of the PT-9500PC ON.
Now, the initialization of the EEPROM on the PT-9500PC is completed.
9)
Click the Check Version button to check whether the initialization was completed
successfully.
10) Click the Close button after the check to exit.
Summary of Contents for PT-9500PC - P-Touch 9500pc B/W Thermal Transfer Printer
